Advanced Functions; Assigning The Aux Key; Reassigning The Dvd•Vcr Key To Control A Vcr; Volume Punch-Through - One for All OARN05G Guia Del Usuario

Advanced Functions

Assigning the AUX Key

To program the AUX key, you must first assign it to a device type.
1. Press and hold the AUX key. The POWER key turns on.
2. While holding down the AUX key, press and release the number
key on the keypad for the device you want to control (the
POWER key turns off):
Additional TV
VCR or DVR
Additional DVD
Additional audio device
Additional satellite receiver,
cable box, or DTV converter
3. Release the AUX key. The POWER key blinks four times and
then turns off. The AUX key is now set to control the device
type you selected.
4. Follow the directions in the auto, brand, direct entry, or manual
code search to program the AUX key.
Reassigning the DVD•VCR Key to
Control a VCR
The DVD•VCR key defaults to control a DVD player. If you want
the DVD•VCR key to control a VCR, you must reassign it.
1. Press and hold the DVD•VCR key. The POWER key illuminates.
Keep holding down the DVD•VCR key.
2. While holding down the DVD•VCR key, press and release the
number 2 key on the keypad. The POWER key turns off.
3. Release the DVD•VCR key. The POWER key blinks four times and
then turns off. The DVD•VCR key is now set to control a VCR.
4. Follow the directions in the auto, brand, direct entry, or manual
code search to program the DVD•VCR key for your VCR.

Volume Punch-Through

Volume Punch-Through allows the VOL and MUTE keys,
when pressed in SAT•CBL•DTC or DVD•VCR modes, to "punch
through" to either TV or AUDIO, whichever was accessed last.
Volume Punch-Through occurs automatically and allows you
to control the volume without exiting the current mode. (If
the AUX key has been programmed with a TV or AUDIO code,
volume can punch through to these devices as well.)
Note: Volume Punch-Through does not occur in cases where
the component code has its own volume/mute controls, such as
some satellite receivers.
Advanced Punch-Through
Volume punch-through as described above occurs automatically.
Advanced punch-through lets you specify one device for all
volume commands for each non-audio mode (SAT•CBL•DTC or
DVD•VCR). You can specify either the TV or AUDIO device (or an
AUX key operating a TV or Audio device).
1. Press and hold the key whose volume commands you want
to send to the TV or audio device. The POWER key turns on.
2. While holding down the device key, press and hold the VOL
up key. The POWER key turns off.
3. After holding down both keys for 3 seconds, the POWER key
turns on and stays on. Release both keys.
4. Press and release the device key you want the Volume
Punch-Through to be directed to from the selected mode
(TV, AUDIO or AUX key). The POWER key flashes.
Note: The device key pressed in step 4 must be programmed
with a TV or AUDIO component. If an invalid key is pressed, the
POWER key flashes four times, then turns off.
Important: Once you have programmed any device with a
specified Volume Punch-Through, the Volume Punch-Through
for all other devices defaults to AUDIO. If you do not want
other components' Volume Punch-Through to default to
AUDIO, you must manually program them, using steps 1-4.
10
press 1
press 2
press 3
press 4
press 5