Learning Tips - One for All OARN05G Guia Del Usuario

Learning From Your Original Remotes
1. Place your original remote and the learning remote on a
flat surface as shown below. Point the top of your original
remote at the top of the learning remote. The IR LED on
the original remote should be pointing directly at the
learning remote's learning sensor, located on the top of the
remote. The remotes should be 1–2 inches apart.
2. On the learning remote, press and hold
the device key you want to use the
learned function in (the POWER key
turns on and remains on). While holding
down the device key, use your other
hand to press and hold the RECORD key
(the POWER key illumination turns off).
3. Wait until the POWER key turns on and
stays on. Then release both keys. The
remote is now in Learning mode.
4. On the learning remote, press the
key you want to use for the learned
function. The illuminated POWER key
blinks once, then remains on.
5. On the original remote, press and hold the key you want
to teach to the universal remote. Wait until the POWER key
on the learning remote blinks once, then release the key
on the original remote. The learning remote has finished
learning this key.
Note: If a problem occurs during the Learning process, the
illuminated POWER key blinks four times, but the unit remains
in the Learning mode. If this occurs, adjust the distance
between the remotes slightly and repeat from step 4.
6. To learn another key for this device mode: Repeat steps
4 and 5 for the key you want to learn.
To learn keys in a different device mode: Repeat steps
2–5 for the next device mode.
To save learned keys and exit learning: press the SLEEP
key on the learning remote.

Learning Tips

• Make sure the batteries in both the learning and original
remote(s) are fresh.
• Incandescent or low-energy light can cause interference
with IR transmissions. When using the Learning function,
keep remotes at least three feet away from such light
sources.
• Make sure the original remote is in the same mode as the
universal remote so that the Learned key is assigned to
the correct mode.
• You cannot learn any commands under the MACRO,
SLEEP, or BACKLIGHTING keys.
• If you use the VOL+/- keys to learn new functions, the
volume control will not adjust the volume in the Volume
Punch Through mode.
• To exit Learning mode at any time, press the SLEEP key.
• The remote exits Learning mode if it has run out of
memory to store new learned keys.
• To ensure that your units are compatible and to increase
your familiarity with the Learning process, experiment
by learning two or three keys initially. Then, carry out
a Master Clear before learning all the desired functions
from your original remote.
1–2"
13