Honeywell HV-140 El Manual Del Propietario página 3

• Remove the packaging
material from the Fan
Control Box.
• Remove the holding
screw from the rear of
the Fan Control Box
(Fig. 1).
• Push the Fan Control Box
Extension through the
opening in the right
leg of the fan base
(Fig.1).
• Be sure your fan is in
the OFF position.
• Set your fan on a dry,
level surface.
• Plug the power cord
into a polarized 120 volt
AC wall outlet.
• Be sure your fan is in
the OFF position and
UNPLUG THE FAN
BEFORE CLEANING.
• Use only a soft, damp
cloth to clean the fan.
• DO NOT immerse the
fan in water and never
allow water to drip into
the Motor Housing.
• DO NOT use gasoline,
paint thinner or other
chemicals to clean the
fan.
ASSEMBLY INSTRUCTIONS
• Replace the holding
screw and firmly tighten
the Fan Control Box onto
the base (Fig. 1).
NOTE: When installing the
Control Box, make sure the
electrical wires are
located on the outside of
the base (Fig. 1).
• Select the desired
speed. For maximum
air circulation, you may
point the fan towards
the ceiling. Using this
method during the
summer and winter will
DW-518 Fig. 2
move the warm air
from the ceiling,
CLEANING AND STORAGE
• To clean the Fan Blade,
use 2 screwdrivers to
disengage the 8 hooks
holding the Front Grille
to the Rear Grille
(Fig. 2).
• Remove the Front Grille.
• Wipe the Blade and
Grilles.
• Reassemble the fan by
snapping the Front
Grille into place.
Fig. 1
OPERATION
dispersing it and giving
you a more uniform
room temperature.
• Adjust the pivoting
head to direct the
powerful breeze where
desired.
• Store the fan in its
original box or cover
the fan to protect it
from dust. Store it in a
cool, dry place.
Fig. 2
FAN
CONTROL
BOX
HOLDING
SCREW