Enclosure Installation; Preparation; Unpacking; Placement - Tripp-Lite SmartRack SRW15US Manual Del Propietário

4. Enclosure Installation

Caution! Read All Instructions and Warnings Before Installation!
Warning: Rack enclosures can be extremely heavy. Do not attempt to unpack, move or install the enclosure without assistance. Use
extreme caution when handling the enclosure and be sure to follow all handling and installation instructions. Do not attempt to install
equipment without first stabilizing the enclosure.

4.1 Preparation

The enclosure must be installed in a structually sound area that is able to bear the weight of the enclosure, all the equipment that will be installed in
the enclosure and any other enclosures and/or equipment that will be installed nearby. Before unpacking the enclosure, you should transport the
shipping container closer to the final installation location to minimize the distance you will need to move the unit after the protective packaging has
been removed. If you plan to store the enclosure for an extended period before installation, follow the instructions in the Storage and Service section.
You need several tools:
• Level
• Phillips-head Screwdriver
• Appropriate tools for wall mounting

4.2 Unpacking

1 Move shipping pallet to a firm, level surface.
Open box and remove the four foam corner protectors. Save all packing materials for later use unless you are certain they will not be required.
2
Packing materials are recyclable.
With one person on each side, carefully lift the enclosure out of the box and place on a firm, level surface.
3
Examine the enclosure for any damage or loose parts. Confirm all parts are present. If anything is missing or damaged, contact Tripp Lite for
4
assistance. Do not attempt to use the enclosure if it has been damaged.
Never extend more than one component from the enclosure at a time.

4.3 Placement

If using the optional casters, you can use the casters to move the enclosure for a short distance
over a level, smooth, stable surface by pushing it from the front or rear (not the side panels). Do
not attempt to roll the enclosure over long distances. The enclosure should be moved close to its
installation location inside its shipping container before it is unpacked. Warning: Do not push or
pull the enclosure at the side panels or pull the enclosure toward you. Only experienced
equipment operators should attempt to lift the enclosure. Use appropriate equipment and
follow all applicable safety procedures and regulations.
Warning: Never attempt to lift or install without adequate help.
You also need the following hardware:
• Appropriate hardware for wall mounting (not included)
Use at least two people to unpack the enclosure.
Do not try lifting the enclosure alone.
3