Quick Installation - Tripp-Lite SmartPro 1U Serie El Manual Del Propietario

Mounting
Tower Mounting
Mount UPS models in an upright tower position
using included hardware. The user must
determine the fitness of hardware and
procedures before mounting.
Stand your UPS on its side with the LED/Control
panel at the top. Attach one rack mounting ear
to each side of the UPS using included
A
screws.

Quick Installation

Plug the UPS into an outlet on a
1
dedicated circuit.*
• Connect the SMX500RT1U AC input to
the outlet using one of the two included
1.8 m C13 to C14 power cords, or
connect with a user-supplied cord.
• SMART500RT1U has an attached cable.
NOTE! after plugging the UPS into a live AC outlet,
the UPS (in "Standby" mode) will automatically
charge its batteries**, but will not supply power to
its outlets until it is turned ON (see Step 3 below).
Note: UPS system will function properly upon
initial startup. However, maximum runtime for the
unit's battery will only be accessible after it has
been charged for 24 hours.
* See Specifications for circuit amperage
requirements.
** The BATTERY CHARGE LED will be the only LED
illuminated.
A
1
SMX500RT1U Shown
SMART500RT1U Shown
1
4
A