bEforE uSE AnD
oPErATIon
INTENDED uSE
This shredder is designed for cutting of fibrous
and woody garden waste for composting.
ASSEMBLING
•Take the machine out of the packaging.
Remove the transport protection. (See Fig A
& B)
•The wheels and stand must be mounted
according to figures C and D.
bEforE uSE
Open the cover of the inlet (15), use the
proper mating connector for connecting
to power supply, before operating the
appliance, ensure the mating connector
is firm connected with inlet.
ALWAyS uSE THE cORREcT SuPPLy
VOLTAGE
The power supply voltage must match the
information quoted on the tool identification
plate.
10
The circuit must at least be protected with 13A
house fuse.
Use only extension cables suitable for outdoor
use, preferably with a high visibility cord color.
With the following specification:
• For extension cables up to 25 meters, a cross
section of 3 x 1.5 mm
• For extension cables over 25 meters, the
cross section must be 2.5 mm
Always completely unwind cable reels.
WARNING! Always place the
machine on solid, level ground. Do
not tilt or move during operation.
Remove earth from roots. Foreign
material such as stones, glass, metals,
fabrics or plastics must not enter the
feed opening. Otherwise this could
damage the cutting roller (12).
Initial Operation (See Fig E)
Silent shredder
is required;
2
.
2
INITIAL OPERATION (See Fig E)
The rotational direction switch (8) must be in
the position to the right. The feed opening (1)
must be empty.
Switching on:
Press the green button 'I' to switch on.
Switching off:
Press the red button 'O' to switch off.
The motor will coast after switching off!
ROTATIONAL DIREcTION SWITcH (8)
Before switching the rotational direction,
always switch the machine off and wait until it
STOPS.
Right position: The cutting roller
pulls in and mulches the material.
Left position: The cutting roller runs
backward and frees jammed material.
OVERLOAD PROTEcTION
Overloading (e. g. blocking of the cutting
roller) causes the machine to stop and the
overload protector will be activated. The on/off
switch (5) will spring to position "O" in a few
seconds. Switch the rotational direction switch
(8) to the left position (backwards).and after a
short period Press the reset button (7) and then
restart the machine.
LED OVERLOAD INDIcATOR
LED overload indicator (6) will illuminate
green one by one as the load becomes
increasingly heavier. When the Yellow indicator
is illuminated, it is indicating that the shredder
load is becoming high. When the red light
illuminates then this indicates that the
shredder load is too high and will eventually
cause the machine to activate the safety cut
out.
NOTE: the reset button will have to be
pushed to reset the machine!
The state of the illuminating of green light is
recommended when operating the machine,
which can increase the life of the machine.
En