Accessories; Preventive Maintenance - ProTeam ProGuard 16 MD El Manual Del Propietario

Your accessories may be stored in the
removable tote. The hose may be stored
by wrapping it around the unit and placing
each end into the two areas marked Hose
Storage.
NOTE: Insert male end of extension wand
into the holder sleeve as shown.
The hose may be stored by wrapping it
around the unit and plugging the open
end into one of the storage locations on
the caddy assembly.

PREVENTIVE MAINTENANCE

CLEANING THE FILTER CAGE AND FLOAT MECHANISM
1. Remove the filter from the filter cage.
2. Press removal tab inward and pivot the
filter cage outward.
3. Clean all debris from cage and float
mechanism.
4. Place the ball float over the opening in the
center of the lid over the hole.
5. Line up filter cage tabs with slots in the
center ring of the lid.
6. Push on the filter cage until the tabs snap
into slots for a secure fit. (Refer to pg 8).
ProTeam

ACCESSORIES

Hose Storage
Area
Accessory Storage Compartment
CORD WRAP
When vacuuming is complete, unplug
the cord and wrap it around the power
assembly as shown. The cord should wrap
under the pull handle (above the inlet)
and around and under the cord wrap of
the motor cover.
Push/Pull Handle
Extension
Wand
Extension
Wand
Storage
(Not Included
On All Models)
Cord Wrap
Power
Cord
11