Cord Maintenance - ProTeam ProGuard 16 MD El Manual Del Propietario

PREVENTIVE MAINTENANCE
CLEANING AND
DISINFECTING THE WET/
DRY VACUUM
To keep your Wet/Dry Vacuum looking
its best, clean the outside with a cloth
dampened with warm water and mild
soap.
To clean the drum:
1. Dump debris out.
2. Wash drum thoroughly with warm
water and mild soap.
3. Wipe out with dry cloth.
Before prolonged storage or as needed
(i.e., waste water pick-up) the drum
should be disinfected.
To disinfect the drum:
1. Pour 1 gallon of water and 1 teaspoon
chlorine bleach into the drum.
2. Let solution stand for 20 minutes,
carefully swishing every few minutes,
making sure to wet all inside surfaces
of the drum.
3. Empty drum after 20 minutes. Rinse
with water until bleach smell is gone.
Allow drum to dry completely before
sealing the motor on the drum.
WARNING: To assure product
!
SAFETY and RELIABILITY, repairs and
adjustments should be performed by
Authorized Service Centers, always
using PROTEAM replacement parts.
ProTeam

CORD MAINTENANCE

When vacuuming is complete, unplug the
cord and wrap it around the motor cover.
If the power cord is damaged, it must
be replaced by the manufacturer or their
service agent or by similarly qualified
personnel to reduce the risk of accident.
STORAGE
Before storing your Vacuum, the drum
should be emptied and cleaned. The cord
should be wrapped around the unit and
the hose should be stored as described
in this manual. Accessories should be
kept in the same area as the Vacuum
so they can be readily available. The
Vacuum should be stored indoors.
CASTERS AND WHEELS
Should your cart squeak or become hard
to roll, you should place two or three
drops of general purpose oil on each
wheel at the axle. If your casters are
noisy, you may put a drop of oil on the
roller shaft to make them quieter.
FRAME AND HANDLES
Your metal handle is painted to prevent
rust, however, liquids and corrosive
debris should be wiped off with a soft
cloth should they come in contact with
the handle.
(Continued)
13