Craftsman 917.28848 Manual Del Operador página 7

Keys
(1) Oil Drain Tube
For Future Use
Slope Sheet
(2) Keys
Your new tractor has been assembled at the factory with the exception of those parts left
unassembled for shipping purposes.
When right or left hand is mentioned in this
manual, it means, from your point of view,
when you are in the operating position (seat-
ed behind the steering wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACKCARTON
1. Cut along dashed lines on all four panels
of carton. Remove end panels and lay
side panels flat.
2. Remove protective materials from tractor
hood and grille.
IMPORTANT: Check for and remove any
staples in skid that may puncture tires where
tractor is to roll off skid.
CHECK BATTERY
1. Lift hood to raised position.
NOTE: If this battery is put into service after
month and year indicated on label (L) (label
is located between terminals) charge battery
for minimum of one hour at 6-10 amps. (See
"BA-I-TERY" in Maintenance section of this
manual for charging instructions).
ADJUST SEAT
1. Sit in seat.
2. Liftupadjustmentlever (A) andslideseat
until a comfortable position is reached
which allows you to press clutch/brake
pedal all the way down.
3. Release lever to lock seat in position.
7
NOTE: You may now roll your tractor off the
skid. Followthe appropriate instruction below
to remove the tractor from the skid.
4(_ WARNING: Before starting, read, un-
derstand and follow all instructions in the
Operation section of this manual. Be sure
tractor is in a well-ventilated area. Be sure
the area in front of tractor is clear of other
people and objects.
TO ROLL TRACTOR OFF SKID
(See
Operation
section for location and
function of
controls)
1. Raise attachment lift lever to its highest
position.
2. Release parking brake by depressing
brake pedal.
3. Place freewheel control in disengaged
position to disengage transmission (See
"TO TRANSPORT" in the Operation sec-
tion of this manual).
4. Roll tractor forward off skid.
5. Remove banding holding the deflector
shield up against tractor.