Instructions For Use; Error Message On The Display - Flex ADM 60 Li Instrucciones De Funcionamiento Originales

FLEX ADM 60 Li

Instructions for use

WARNING!
– Do not point the laser beam at people or
animals.
– Do not look into the laser beam.
– Do not put any optical instruments in the
path of the beam.
This measuring instrument generates laser
radiation which may cause blindness.
CAUTION!
– Do not use the measuring instrument
in a damp, dusty or sandy environment.
Device components may be damaged.
– If the device is brought from a very cold
to a warmer environment or vice versa,
you should allow the device to acclimatise
before using it.
– If using adapters and tripods, ensure that
the device is screwed on tightly.
The most important operating steps are
explained at the end of these instructions
on the illustrated pages.
See from page 150.
14
Battery charging with USB cable and
USB charger ........................................... 150
Switching the device on and off ............. 152
Setting unit of measurement .................. 154
Selecting reference point ....................... 156
Setting measuring mode ........................ 158
Linear measurement .............................. 160
Area measurement ................................ 162
Volume measurement ........................... 166
Single Pythagorean ............................... 170
Double Pythagorean .............................. 174
Continuous measurement ..................... 178
Maximum/minimum measurement ........ 180
Addition and subtraction ........................ 184
Checking precision ................................ 188

Error message on the display

Error code Cause
➜ Remedy
001 The reflected laser beam is too intense.
➜ Do not aim at highly reflective surfaces;
if required cover (e.g. with paper).
002 Measurement range exceeded.
➜ Take measurements within the range
of 0.2 to 60 m only.