Blaupunkt PG3000 Manual De Instrucciones página 5

Y COMPONENTS
4
3
2
1
-
BEFORE USE - PREPARATION
To test the viscosity
This unit cannot be used for textured paints. Use of these materials will cause premature wear to the unit, which will void the
guarantee. To obtain the best results from the Paint Sprayer, please read the instructions fully before use and retain for future
reference.
• intended for use ONLV with
• painting liquids with a flashpoint above 70ºF (21ºC).
This Paint Sprayer can be used with products having a viscosity ranging from 25 to a maximum of 50 seconds.
IMPORTANT - Always read the manufacturer's warnings and guidance on the container before use.
DO NOT spray any material where any hazards are not known.
Material Runout
1) Oil enamel
2) Oil based primer
se
3) Oil stain
4) Clear sealer
he
5) Polyurethan
6) Varnish
9
8
5
6
7
Time in Seconds
25-40
30-45
No thinning required
No thinning required
No thinning required
20-50
1. Air cap
2. Nozzle
3. Nut
4. Gun body
5. Volume adjustable screw
6. Trigger
7. Container
8. Switch
9. LED Light