Material Disposal - Blaupunkt PG3000 Manual De Instrucciones

y
ir
n

MATERIAL DISPOSAL

• Diluting/thinning agents and remainders of paint material must be disposed of in an environmentally friendly manner.
Observe the manufacturer's disposal information and local regulations for the disposal of hazardous waste.
• Chemicals harmful to the environment may not be disposed of into soil, groundwater or bodies of water. Never pour
chemicals harmful to the environment down the drain and/or into the sewerage system.
MAINTENANCE
• You should inspect the side air filters in the turbine regularly to see if they are excessively dirty. lf they are dirty, follow
the steps below to clean.
• Switch off the Sprayer and unplug from the mains.
• Remove the screws on the two turbine filter covers (one on each cover).
• Slide off the filter covers to remove.
• Check if the filters are dirty.
• lf the filters are dirty, rinse in clean water and leave to air dry.
IMPORTANT- NEVER operate the Sprayer without the air filters in place. Dirt could be sucked into the turbine and may
•
interfere with the operation of the spray gun.
n
TECHNICAL LNFORMATION
h
Voltage (V)
W
Power (W)
er
Rating frequency
Protection class
Spraying capacity
Container capacity
Mass of Paint Sprayer
Ingress protection
Repeat this process until clear cleaning solution emerges from the spray gun.5.
Re-attach the container to the gun, plug in the Sprayer and turn on.
6. IN A SAFE AREA - ln an empty material tin, spray the solution through the gun for
approximately 2 seconds, release the trigger and spray again for approximately 2 seconds.
Repeat this process until clear cleaning solution emerges from the spray gun.
7. Unplug the Sprayer and then pull the trigger so the remaining material flows back into the
container.
8. Unscrew the container again. Empty the container of any remaining cleaning solution and
dispose of the liquid in the correct manner. Wipe the exterior of the paint container and the
gun until clean.
9. Unscrew the nut (clean), then remove the air cap and nozzle and clean. Remove the suction
tube and clean - use an appropriate cleaning solution
Check the container seal and clean with water if required.
NOTE - There is a small rubber washer located inside the nozzle, ensure this is in place
before reassembly.
10. After cleaning the spray gun carefully reassemble.
NOTE - lf the spray nozzle becomes clogged during spraying, please refer to cleaning
points 1, 9 and 1O above.
230-240 V
450 W
50 Hz
II
750 ml/mim
800 ml
1.13 kg
IP20