Kenmore HE2t Serie Manual De Uso Y Cuidado página 6

Selecting theproper location f oryour w asher improves
performance andminimizes noise a ndpossible washer "walk."
Your washer canbeinstalled under acustom counter, orina
basement, laundry room, closet, orrecessed area. S ee "Drain
System."
Companion appliance location r equirements should a lso be
considered. Proper installation isyourresponsibility.
You will need
• A water heater set to deliver 120°F (49°C) water to the
washer.
• A grounded electrical outlet located within 6 ft (1.8 m) of
where the power cord is attached to the back of the washer.
See "Electrical Requirements."
• Hot and cold water faucets located within 4 ft (1.2 m) of the
hot and cold water fill valves, and water pressure of
20-100 psi (137.9-689.6 kPa).
• A level floor with a maximum slope of 1" (2.5 cm) under entire
washer. Installing the washer on soft floor surfaces, such as
carpets or surfaces with foam backing, is not recommended.
• A sturdy and solid floor to support the washer with a total
weight (water and load) of 400 Ibs (180 kg).
Do not operate your washer in temperatures below 32°F (0°C).
Some water can remain in the washer and can cause damage in
low temperatures.
Installation clearances
• The location must be large enough to allow the washer door
to be fully opened.
• Additional spacing should be considered for ease of
installation and servicing. The door opens more than 90 °, and
it is not reversible.
• Additional clearances might be required for wall, door, and
floor moldings.
• Additional spacing of 1" (2.5 cm) on all sides of the washer is
recommended to reduce noise transfer.
• Companion appliance spacing should also be considered.
Washer Dimensions
601/4"
(127.6crn)
27"
(68.6 cm}
30"
(91.4cm)
Door is not reversible.
Recommended installation spacing for custom
undercounter installation
The dimensions shown are for the recommended spacing.
Custom undercounter installation - Washer only
(
37" min,
(98.9crn)
1" _7%,. 27"--._ 1"
(2.5 crn} (68.6 cm) (2.5 cm)
Recommended installation spacing for recessed or
closet installation, with or without a pedestal
The dimensions shown are for the recommended spacing.
Recessed area or closet installation
_LL114,,,m0x.
--_11"1_-8ova"-*1 4" _--
(2.6 cm) (77.8 cm) (10.2 cm)
A
48 in?*_
(310crn 2)
24in.2._
(188cm2)
A. Side view - closet or confined area
B. Closet door with vents
*Min. top and bottom air openings for closet door.
Recessed or closet installation - Washer on pedestal
1" -_41_- 27"-_41_- 1"
(2.5 cm) (68.6 cm) (2.5 cm)
14"*max. '_-
--_-I 1"_ 8ov_"_1 4" I_--
(2.5 cm) (77.5cm) (10.2cm}
A B
A. Recessed area
B. Side view - closet or confined area