Briggs & Stratton TROY-BILT 020764 Manual Del Operador página 9

3. Turn on water, point spray gun in safe direction, press
trigger lock and depress trigger to purge pump system
of air.
4. Attach spray wand to spray gun. Tighten by hand.
Step 4: Spray Tips
1. Select desired spray tip:
Low Pressure
Black Soap
Use to apply
detergent
General Rinse
Yellow, 15°
Siding /
Patios Decks
Driveways /
Garage Floors
2. Pull spray wand quick connect collar back, insert
spray tip and release. Tug spray tip to ensure it is
secure.
Step 5: Start Up
NOTICE Do not start engine without water supply
connected and turned on.
1. Level product before starting.
2. Push engine switch to ON (I) position.
Delicate Rinse
• Always wear indirect vented (chemical splash) safety
White, 40°
goggles when using or near this product. (Safety glasses
Green, 25°
do not provide full protection).
Cars / Vans
• Always wear protective clothing such as long-sleeved
/ Trucks /
shirts, long pants and closed-toed shoes.
Outdoor
NOTICE A ReadyStart® engine requires no priming or
Furniture
choking.
Maximum
Rinse
Red, 0°
Paint Removal
broken bones, fractures, bruises, or sprains and result in
/ Oil Stains
serious injury.
/ Rust Removal
3. Position yourself as shown below, grasp recoil starter
4. Return recoil starter slowly. Do not let rope "snap back"
Engine Switch
OR
WARNING! Risk of eye injury. Spray could
splash back or propel objects, resulting in
serious injury.
WARNING! Recoil starter kickback (rapid
retraction) will pull hand and arm toward engine
faster than you can let go, which could cause
and pull slowly until you feel some resistance. Then
pull rapidly to start engine.
against starter.
9