Safety Warnings For Polishers; Kickback And Related Warnings - Truper PULA-7N Manual De Instrucciones

Safety warnings for
polishers
• Never have the car running when using the polisher in an
enclosed place.
• Before starting the polishing job, make a test. In the
event the tool makes strange sounds or vibrates in an
unusual way, please turn it off. Disconnect it and take it to
a Authorized Service Center.
• When not in service the tool shall be turned off and
disconnected.
• Prevent unexpected starting. Keep your fingers away
from the On /Off switch when connecting the tool into the
power outlet.
• To prevent electric shock, keep the tool dry and clean,
free of any oil or grease residue.
CAUTION
• Keep the power cable away from the
tool trajectory while polishing. Otherwise the disc can trap
and cut the cable exposing the user to electric shock.
• Do not force the tool. Hold it firmly by both handles. Do
not use force downwards, otherwise the tool movement
will slow down, reducing quality in the job and severely
damaging the tool.
• Take good care of the tool. The job is easier if it is in
good conditions.
CAUTION • Do not use accessories which are not
specifically designed and recommended by the tool
manufacturer. The fact that an accessory item may fit the
power tool is not an assurance of safe operation.
CAUTION
• Do not use accessories that require
liquid coolants. Using water or other liquid coolants may
result in electrocution or shock.
CAUTION • Do not allow any loose portion of the
polishing bonnet or its attachment strings to spin freely.
Tuck away or trim any loose attachment strings. Loose and
spinning attachment strings can entangle your fingers or
snag on the workpiece.
WARNING
• Wear safety glasses.

Kickback and related warnings

Kickback is the result of power tool misuse and/or
incorrect operating procedures or conditions and can be
avoided by taking proper precautions as given below.
• Maintain a firm grip on the power tool and position your
body and arm to allow you to resist kickback forces.
Always use auxiliary handle, if provided, for maximum
control over kickback or torque reaction during start-up.
The operator can control torque reactions or kickback
forces, if proper precautions are taken.
• Never place your hand near the rotating accessory.
Accessory may kickback over your hand.
• Do not position your body in the area where power tool
will move if kickback occurs. Kickback will propel the tool
in direction opposite to the wheel's movement at the
point of snagging.
• Use special care when working corners, sharp edges etc.
Avoid bouncing and snagging the accessory. Corners,
sharp edges and bouncing have a tendency to snag the
rotating accessory and cause loss of control or kickback.
5
ENGLISH