Telcoma Automations WIKI Manual De Instrucciones página 31

GB
This manual is for qualified technical personnel only for installation purposes
·
and not intended for the end user; it's the installer's job to explain to the user
how the automatism works, about possible hazards related to it and about the
need for periodical maintenance.
The automatism must be installed by qualified personnel only, observing
·
current standards concerning automatic closing systems. More specifically,
installation conformity calls for observance of directive 89/392 and standards
EN 12453 and EN 12445.
As WIKI is made specifically to control swing gates it is forbidden to use the
·
product for different purposes or improperly.
Use original components only. Telcoma is not liable for damages if other
·
components are used.
Make certain that the gate structure is solid and suitable for being motor-
·
driven.
When the gate is moving make sure there are no points of friction and there is
·
no chance of it derailing.
Make absolutely certain the power is disconnected before carrying out any
·
work on the device.
Connect the power lead to supply lines with adequate electrical protection
·
only; install a device to guarantee disconnection of all the phases from the
mains that has a distance of at least 3.5 mm between the contacts.
Pay particular attention when deciding which safety devices to install and their
·
location. Always install an emergency stop device that will cut power off in the
case of necessity.
Only qualified personnel must be allowed to service the unit and access the
·
internal parts of the geared motor.
Irreversibility of the geared motors means an electric lock does not have to be
·
installed and, in the case of black-out the release device (protected by a
personalised key) lets you open the gate by hand. We do however recommend
using an electric lock to ensure correct closing especially if the swing gates are
longer than 2.5 metres.
Attention!
!
31