Hilti SC 70W­A22 Manual De Instrucciones página 33

5.1.7 Setting the miter cut angle
1. Remove the battery.
2. Release the cutting angle adjustment clamping lever.
3. Pivot the product into the desired position.
The cutting angle preset makes it easy to set the maximum angle (22.5°, 45°, 50°)
4. Tighten the cutting angle adjustment clamping lever.
5.1.8 Sawing along a line
At the front edge of the base plate of the circular saw is a line indicator for straight cuts and miter cuts
(0° and 45°). This permits accurate cutting at the desired miter angle. The edge of the line indicator
corresponds to the inside of the saw blade. There is a cutting line indicator at the opening for the saw
blade at the front end of the base plate.
Secure the workpiece to prevent movement.
Position the workpiece so that the saw blade is free to rotate beneath it.
Check to ensure that the on/off switch on the power tool is in the "off" position.
Position the forward section of the saw's base plate on the workpiece but do not bring the blade into
contact with the workpiece.
1. Insert the battery.
2. While pressing the safety lock, switch the product on by pressing the on/off button.
3. Guide the product along the cutting line on the workpiece at a suitable speed.
5.1.9 Installing / adjusting the fence
1. Remove the battery.
2. Screw the clamping screw into the base plate, leaving enough space to slide the fence through.
3. Slide the fence guide under the clamping screw.
4. Set the fence to the correct width for the cut.
5. Tighten the clamping screw.
The fence (single-arm/twin-arm) can be fitted on either side of the base plate. The twin-arm fence
can be used only with the large base plate
The fence can be used to make accurate cuts along the edge of a workpiece or to rip strips of
equal width.
5.1.10 Fitting the guide rail adapter
The saw can be equipped with a guide rail adapter which is available as an accessory.
When using saws with a small base plate, please use a guide rail adapter that fits the guide rail.
1. Remove the battery.
2. Remove the fence, if fitted.
3. Fit the base plate into the side retaining channels of the guide rail adapter.
4. Fully insert the base plate into the guide rail adapter.
5. Lock the guide rail adapter by pressing in the two sliders as far as they will go.
5.2 Work
5.2.1 Switching on
▶ While pressing the safety lock, switch the product on by pressing the on/off button.
5.2.2 Switching off
▶ Release the on/off switch to stop the machine.
*2092401*
Printed: 30.04.2019 | Doc-Nr: PUB / 5206169 / 000 / 03
6
7
8
9
2092401 English 27