Charging Your Yeti; Charging From Solar; Charging From The Wall - Goalzero YETI 400 Manual Del Usuario

Charging Your YETI

CHARGE ME NOW: Before using or storing, plug your YETI into the wall
until it is fully charged. If at any point you hear a beeping from your YETI,
plug it into a power source, like an AC outlet or a solar panel, as soon as
possible. This built-in warning indicator is to help prevent battery damage
when the charge gets low. For more tips and tricks on keeping your battery
healthy, see the BATTERY 101 section.
LCD Battery Display: The LCD Battery Display indicates the charge level
of your YETI. There are 5 segments to the battery, approximating 20% -
40% - 60% - 80% -100% capacity. As you use your YETI, segments will
disappear from the display, indicating the remaining charge. When charging
your YETI you will notice a battery segment blinking at a 1 second interval.
This indicates the current charge status. Once your YETI is fully charged,
all battery segments will be lit and remain solid.

Charging from Solar

The YETIs charging port is located on the top-left corner of the faceplate
and has a blue ring around it. This 8mm port is designed to work with Goal
Zero solar panels and is capable of taking in 120W of solar.
1. Place your solar panel where it will get as much direct sunlight as
possible. See the graphic in the SOLAR 101 section for help.
2. Insert the blue-ringed plug form the panel into the INPUT port on the
front of the YETI. You will know the YETI is charging when the blue LED
light next to the INPUT port lights up, and the battery segments in the
LCD BATTERY DISPLAY are blinking. The YETI is fully charged when all
battery segments stop blinking and remain solid.
3. Some GOAL ZERO panels are chainable to provide more power to
your YETI and reduce solar charge times. The INPUT port is capable of
taking in 120W of solar.
When connecting older versions of the NOMAD and BOULDER Solar Panels,
use the Legacy-Nomad Adapter Cable or the 8.0mm to 8.0mm Adapter Cable
to connect to the YETI.
4
5 Hours

Charging from the Wall

Using the included AC Wall Charger, plug your YETI into any wall outlet. Y ou will
know the Y eti is charging when the blue LED light next to the INPUT port turns
on, and battery segments in the BATTERY DISPLAY are blinking. The YETI is fully
charged when all battery segments stop blinking and remain solid. The YETI should
recharge from the wall in about 5 hours.
Charging from your Car
To charge your YETI from a car or 12V source, you will need to purchase
an 8.0 mm to 12V charger from GOALZERO.com. Call our Customer
Solutions Center at 1-888-794-6250 for help identifying the charger.
1. The AC wall charger comes in two pieces.
Connect the two pieces by plugging the
cable into the box
5