9. SNOOZE (TOP OF CABINET): When the Alarm sounds, press, hold, and then release the
Snooze button to silence the Alarm for approximately 5 minutes. After 5 minutes, the alarm will
automatically resume. The Snooze time is not adjustable.
10. CLOCK: This quartz analog clock features a fine mechanical quartz movement for superb
accuracy. The clock operates off of a single "AA" battery so power failures will not affect the
clock's accuracy. Check the battery annually so the clock remains accurate. The clock's illu-
mination cannot be turned off or adjusted. It is normal for the light to take several seconds to
extinguish if the power supply is disconnected.
Important Note: Due to the nature of the alarm thumbwheel's analog mechanism, which was
designed for simplicity, there can be up to a five-minute deviation from when the alarm acti-
vates. For example, if the alarm is set for 10:00, it is possible it could activate at 9:55 or 10:05.
We recommend you set the alarm early the first time you use it to accommodate for this. As
you use your Model Three BT you will get a better idea of where you need to set the alarm in
order to wake-up at the desired time.
Guide To Features (Rear Panel)
1. BALANCE: With the Stereo or Dual Alarm Speaker (sold separately) conected, set the Mono/
Stereo switch to Stereo. Turn the balance knob upward to hear the left (main unit) speaker, or
downward to hear the right (Stereo) Speaker. The center detent provides equal balance between
the two speakers.
2. R SPR: Connect the male RCA cable from the right Stereo Speaker or Dual Alarm Speaker (sold sepa-
rately) to this input and switch the Stereo/Mono switch to Stereo. Connecting a speaker other than
the Tivoli Audio Stereo or Dual Alarm Speaker will void your warranty and possibly damage your unit.
3. 12VDC: Connect the included AC power supply to this input or use an optional DC power supply.
Do not connect the power supply to an electrical outlet controlled by a switch because if the
switch is turned off by mistake, the alarm will not wake to the radio when set. Use only the power
supply provided with this product. Should the power supply get damaged or misplaced, use
only a like replacement. The connector is 5.5 mm/2.1 mm center positive.
9 – ENGLISH
1
10
9
8
1.5A
3
7
6
2
5
13
4
CHECK
ANNUALLY
11
12
14