Remington Power Pro 500V Instrucciones De Operación página 21

Tool Disassembly and
Assembly
G. REMOVING ADVANCE BAR
1. Using a 3mm hex wrench, loosen screws on cover and remove.
2. Remove advance pin with hammer and punch.
3. Remove advance bar and spring.
Advance Bar and Spring
Screws
Cover
Housing
Advance Pin
Figure 11 - Removing Advance Bar
H. REMOVING BAFFLE ASSEMBLY
1. Loosen and remove baffle assembly and o-ring.
Housing Handle
O-Ring
Baffle Assembly
Figure 12 - Removing Baffle
I. REMOVING OUTER LINER ASSEMBLY FROM HOUSING
1. Grasp outer liner assembly and firmly pull from housing.
Outer Liner Assembly
Housing
Figure 13 - Removing Outer Liner Assembly
TOOL ASSEMBLY
A. INSERTING OUTER LINER ASSEMBLY INTO HOUSING
1. Firmly push outer liner assembly into housing (see Figure 14).
Housing
Outer Liner Assembly
Figure 14 - Inserting Outer Liner Assembly
21
114918