Krups PERFECT MIX KB403 Manual De Instrucciones página 18

USING THE HERB CHOPPER (K) AND SPICE GRINDER
– With the herb chopper (K) you can chop ingredients like onions, garlic or raw meat
(pre-cut into small pieces) in a few seconds. Do not use the herb chopper for liquid
preparations (fruit juices, etc.).
– With the spice grinder (L) you can grind spices in a few seconds: coriander seeds,
peppercorns, etc.
– These accessories are equipped with a bowl (M) that prevents access to the blades
during use.
1. Turn the bowl (M) upside down and add the ingredients.
2. Position the seal (K1 or L1) in its recess on the blade unit (K2 or L2) (Fig. 5). Position
the blade unit on the bowl. Lock the accessory by rotating the blade unit until fully
assembled (Fig. 6). Caution: leaks can occur if the accessory is not locked
correctly.
3. Rotate the assembled accessory (K or L) and position it on the motor unit (Fig. 7).
4. Then turn the assembled accessory (K or L) through a quarter turn clockwise (Fig. 7).
5. Plug in the appliance and turn the Control knob (E) to the desired position or apply a
few pulses. To stop the appliance, turn the control knob (E) to position zero.
6. Unlock the accessory by turning it through a quarter turn in the anticlockwise
direction. Remove the assembled accessory (K+M or L+M) from the motor unit.
Turn it over before opening to avoid any spillage of your preparation. Then you can
unlock the blade unit (K1 or L1). The blades are very sharp: handle them with
caution to avoid injury. You can then remove the preparation in the bowl.
Warning : you can use the accessories with solid ingredients only. You can pour liquid
ingredients in the blender jug (F) only.
„ Depending on the nature of the ingredients, you can use the blender jug to prepare up to
* 1.5 L for thick mixtures.
* 1.25 L for liquid preparations.
Warning : Do not pour boiling liquids (over 80°C/176°F) in the jug.
„ You can prepare finely blended soups, cream soups, stewed fruit, light batter (pancakes,
fritters, Yorkshire pudding batter, etc.), milkshakes, smoothies, cocktails, etc.
„ If ingredients stick to the sides of the jug when blending, stop the appliance. Remove the
blender jug from the motor unit, and push the food down onto the blades using a spatula
and put your blender jug back to continue your preparation.
„ Always pour the liquid ingredients into the blender jug first, before adding the solid
ingredients, without exceeding the maximum level.
„ To add ingredients while blending, remove the lid cap (F6) from the lid (F5) and add the
ingredients through the feeder hole.
„ For finely crushed ice, use a maximum of 6 small ice cubes using "Ice crush" function.
There is no need to add water.
15
(L)(DEPENDING ON MODEL)
ADVICE