Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
When the time is set, it will begin to count down
immediately. The display will show the remaining time and
the timer indicator will flash for 5 seconds
Buzzer will beep for 30 seconds and the timer indicator
shows "H" when the setting time finished.
Hint:
a) Touch the "-" or "+" control of the timer once to decrease or increase by 1 ;
Note:
a) If you want to change the time after the timer is set, you have to start from step 1.
b) The method for setting two zones is the same as mentioned above.
Switch Control
This function can be used only if there is a timing case ; The purpose is to switch power and time display, so as
to be able to know the value of time or power
Over-Temperature Protection
A temperature sensor equipped can monitor the temperature inside the ceramic hob. When an excessive
temperature is monitored, the ceramic hob will stop operation automatically.
Residual Heat Warning
When the hob has been operating for some time, there will be some residual heat. The letter " H "appears to
warn you to keep away from it.
Default working times
Another safety feature of the hob is automatic shutdown. This occurs whenever you forget to switch off a
cooking zone. The default shutdown times are shown in the table below:
Power level
Default working timer (hour)
1
2
3
4
8
8
8
4
28
INDUCTION COOKER
TPI028210MD
5
6
7
8
4
4
2
2
9
2
Publicidad
Tabla de contenido
