Telstar TPI028210MD Manual De Instrucciones página 35

Connecting the hob to the mains power supply
a) The power supply should be connected in compliance with the relevant standard, or a single-pole circuit
breaker. The method of connection is shown below.
b) For power cord with plug, it can be used directly
1.
If the cable is damaged or needs replacing, this should be done by an after-sales technician
using the proper tools, so as to avoid any accidents.
2.
If the appliance is being connected directly to the mains supply, an omnipolar circuit breaker
must be installed with a minimum gap of 3mm between the contacts.
3.
The installer must ensure that the correct electrical connection has been made and that it complies with
safety regulations.
4.
The cable must not be bent or compressed.
5.
The cable must be checked regularly and only replaced by a properly qualified person.
The bottom surface and the power cord of the hob are not accessible after installation
This appliance is labeled in compliance with European directive 2012/19/EU for Waste Electri-
cal and Electronic Equipment (WEEE). By ensuring that this appliance is disposed of correctly,
you will help prevent any possible damage to the environment and to human health, which
might otherwise be caused if it were disposed of in the
wrong way.
The symbol on the product indicates that it may not be treated as normal household waste. It should be taken
to a collection point for the recycling of electrical and electronic goods.
This appliance requires specialist waste disposal. For further information regarding the treatment, recover and
recycling of this product please contact your local council, your household waste disposal service, or the shop
where you purchased it.
For more detailed information about treatment, recovery and recycling of this product, please contact your
local city office, your household waste disposal service or the shop where you purchased the product.
35
INDUCTION COOKER
TPI028210MD