Numark NS FX Guia De Inicio Rapido página 3

FEATURES
2 3 4
1. USB CONNECTION – Attach this cable to a free USB port on your
computer. NSFX's LEDs will illuminate when the connection is made.
2. SOURCE – Selects the channel that will be sent through the effect.
You can select one of the following (which will be displayed in the
software):
• DECK A – The effect will be heard on Deck A.
• DECK B – The effect will be heard on Deck B.
• AUX –The effect will be heard on the MIC / AUX channel.
• MIX – The effect will be heard on the entire (Master) mix.
3. FX SELECT – Turn this knob to select an effect to apply to the channel, which will be displayed in the
software. You can also press the knob to move automatically to the next effect.
4. FX MIX – Adjusts the amount of the effect, which will be displayed the software. To hear less of the
effect (a "dry" mix), move this fader to the left. To hear more of the effect (a "wet" sound), move this
fader to the right.
5. FX PARAM – Turn this knob to adjust the parameter of the effect, which will be displayed in the
software.
6. FX ON / OFF – Press this button to activate or deactivate the effect. The button's LED will illuminate
when the effect is on.
7. TAP TEMPO – Tap this button at the desired tempo to enter a BPM manually, which will help
determine the speed of rate-based effects. This BPM reading will be shown in the software. You can
tap this button to enter a new tempo at any time, or you can return to the track's auto-BPM by holding
the button down (see TEMPO SOURCE for more information).
SERATO ITCH EFFECTS PANEL OVERVIEW
1
1. NEXT EFFECT – The next effect in the sequence of available effects. Press the NSFX's FX SELECT
knob to select this effect.
2. CURRENT EFFECT – The currently selected effect applied to the channel (if the NSFX's FX ON / OFF
button is set to "on"). When the effect is on, the CURRENT EFFECT and NEXT EFFECT windows will
light up.
3. FX MIX – The amount of CURRENT EFFECT, which can be adjusted with the NSFX's FX MIX fader.
4. PARAMETER – The parameter for the CURRENT EFFECT, which can be adjusted with the NSFX's
FX PARAM knob. Generally, this is the intensity of the effect but may vary between effects.
5. SOURCE – The channel to which the CURRENT EFFECT is being applied. You can select the
channel with the NSFX's SOURCE knob.
Note: When both SOURCE fields are set to the same channel, that channel will pass through the left
effect then the right effect.
6. TEMPO SOURCE – The current BPM for the track, which helps determine the speed of the CURRENT
EFFECT (if it is rate-based). When this field reads "AUTO A" or "AUTO B," the effect will automatically
follow the BPM of the track on Deck A or Deck B, respectively. If "MANUAL" is shown, it means neither
Deck's track has a BPM. You can set the BPM (and change it at any time) by using the NSFX's TAP
TEMPO button. You can also return to the track's auto-BPM by holding down TAP TEMPO.
5 6 7 7
2 3
2
6 5 4
4
3 2 1
Note: In order to use your
NSFX, you will need two
free USB ports on your
computer – one for NS7,
one for NSFX.
5 6