Mode Button; Range Button - koban KPA-12 Instrucciones Operativas

Non-Contact AC Voltage Measurements
WARNING: Risk of Electrocution. Before use,
always test the Voltage Detector on a known live
circuit to verify proper operation
1. Touch the probe tip to the hot conductor or insert into the hot side of the electrical outlet.
2. If AC voltage is present, the detector light will illuminate.
NOTE: The conductors in electrical cord sets are often twisted. For best results, rub the probe tip along a
length of the cord to assure placing the tip in close proximity to the live conductor.
NOTE: The detector is designed with high sensitivity. Static electricity or other sources of energy may
randomly trip the sensor. This is normal operation

MODE BUTTON

To select DC/ACV,OHM/ Diode/Continuity/CAP,
Data Hold Button
To freeze the LCD meter reading, press the data hold button. The data hold button is located on the
left side of the meter (top button). While data hold is active, the HOLD display icon appears on the
LCD. Press the data hold button again to return to normal operation.
REL BUTTON
For DCA and Capacitance Zero & Offset adjustment.

RANGE BUTTON

When the meter is first turned on, it automatically goes into AutoRanging. This automatically selects the best
range for the measurements being made and is generally the best mode for most measurements. For measurement
situations requiring that a range be manually selected, perform the following:
1. Press the RANGE button. The "Auto Range" display indicator will turn off, The "Manual Range" display
indicator will turn on
2. Press the RANGE button to step through the available ranges until you select the range you want.
3. Press and hold the RANGE button for 2 seconds to
exit the ManualRanging mode and return to AutoRanging.
Battery Replacement
1. Remove the one rear Phillips head screw
2. Open the battery compartment
3. Replace the Requires One 9V battery
4. Re-assemble the meter
www.grupotemper.com
KPA-12
AC/DC CLAMP METER
7
KPA-12
AC/DC CLAMP METER
8 www.grupotemper.com