Safety Instructions - auna MVD-400 CP Manual De Instrucciones

EN
22

SAFETY INSTRUCTIONS

Installation Cautions
• The said product is powered via 12 V and before installation, please
check to ensure the voltage of the automobile is correct.
• In the wiring process, tear down the battery's negative connecting wires
so as to avoid electric shock or personnel injury due to short-circuit.
• Try not to connect wires over or near any hot surface, especially those
wires connected to the engine accessories.
• It is forbidden to dismantle the power cable of the said product and
meanwhile, use such cable to power other products of different model.
Over-current is likely to lead to fire disaster.
• Replace old fuse with a new one with the same specifications.
• Install the said product with supplied screws.
• Bundle wires and cables together or via tapes when installation is
completed.
• Do not use the said product in a rainy, damp or dusty environment.
• Do not install the said product in a location that vibrates or is hard to
secure.
• Try not to block any ventilation or radiation openings.
General Instructions
• Do not modify or dismantle the said product on your own so as not to
trigger any accidental events, fire hazard and electric shock.
• For the sake of driving safety, try to keep the volume down.
• While washing the automobile, necessary caution must be exercise as
electric short-circuit or other hazards could be set off if any water is
splashed over the said product (including the speakers).
• Wiring and installation are required to be performed by professionals.
As skills and experience are essential while installing the said product
and connecting relevant wires and cables, it is strongly suggested to
contact relevant dealers for installation.
• If detected any abnormality, please stop using the said product
immediately. Otherwise, such product could be damaged more
seriously. For details, contact the corresponding professional
technicians.
• As the said product consists of numerous precision components, any
attempt to dismantle or adjust any component is strictly restricted.
When maintenance is needed, please send such product to the
locations as appointed by the company for maintenance.