Intended Use Of This Power Tool; Prohibited Use Of This Power Tool - Evolution R255SMS-DB Instrucciones Originales

www.evolutionpowertools.com
SAFETY LABELS & SYMBOLS
(1.8)
WARNING: Do not operate this machine if
warning and/or instruction labels are missing
or damaged. Contact Evolution Power Tools for
replacement labels.
Note: All or some of the following symbols may
appear in the manual or on the product.
Symbol Description
V
A
Amperes
Hz
Hertz
min (RPM)
-1
Speed
~
Alternating Current
n
No Load Speed
o
Wear Safety Goggles
Wear Ear Protection
Do Not Touch,
Keep hands away
Wear Dust Protection
Wear Hand Protection
CE certification
ETL Certification
Regulatory Compliance Mark RCM)
for electrical and electronic equipment.
Australian/New Zealand Standard
The Eurasian Conformity Mark (EAC)
Eurasian Customs Union
Waste Electrical and
Electronic Equipment
Read Manual
WARNING
Laser Warning
Double Insulation Protection
Triman - Waste Collection
& Recycling
FOR ALL DOUBLE-INSULATED TOOLS
1. Replacement Parts
When servicing use only identical replacement parts.
2. Polarized Plugs
To reduce the risk of electric shock, this equipment
has a polarized plug (one blade is wider than the
other). This plug will fit in a polarized outlet only
one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet. Do
not change the plug in any way.
Volts

INTENDED USE OF THIS POWER TOOL

FOR NON-NORTH AMERICAN MODELS ONLY
WARNING: This product is a Multi-material
sliding mitre saw and has been designed to be
used with genuine Evolution blades rated for
this machine. Only use blades designed for use
in this machine and/or those recommended
specifically by Evolution Power Tools Ltd.
WHEN FITTED WITH A CORRECT BLADE THIS
MACHINE CAN BE USED TO CUT:
• Wood, Wood derived products
(MDF, Chipboard, Plywood, Blockboard,
Hardboard etc),
• Wood with nails,
• 50mm mild steel box section with 3mm wall at
HB 200-220,
• 6mm mild steel plate at HB 200-220.
Note: Wood containing non-galvanised nails or
screws, with care, can be safely cut.
Note: Not recommended for cutting galvanised
materials or wood with embedded galvanised nails.
Cutting galvanised steel may reduce blade life.
PROHIBITED USE OF THIS
POWER TOOL
WARNING: This product is a Multi-material sliding
mitre saw and must only be used as such. It must
not be modified in any way, or used to power any
other equipment or drive any other accessories
other than those mentioned in this Instruction
Manual.
WARNING: This product is not intended
(1.13)
for use by persons (including children) with
reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless
they have been given supervision or instruction
Fuse
concerning the safe use of the product by a
person responsible for their safety and who is
competent in its safe use.
5
EN