Publicidad
Idiomas disponibles
Idiomas disponibles
To use
Adjusting the length of the safety straps: Untie the safety straps and adjust the length so that the distance between the
netting and the oval shaped part is the same as the width of the mattress.
The length of the strap can be adjusted using the clasp.
1
To install on bed:
Keeping the bed rail upright, slide the bed rail feet beneath the mattress. (It may be necessary to lift the edge of the
mattress to position Bed railfeet easily). Push bed rail all the way in until it is flush against the side of the mattress.
WARNING
To prevent the risk of strangulation, it is essential to ensure that when the bedguard is fitted into position, there is a gap of
at least 250 mm, between each end of the bed and the corresponding end of the bedguard (fig. 1).
1. Position the bed rail so that the distance between the end of the bed rail
and the headboard is at least 25 cm (10 inches) wide.
2. Bed rail must securely touches the side of mattress tightly and the fixings
are all in places.
3. Top edge of bed rail must be at least 16 cm (6,3 inches) above top edge of
mattress.
4.Fix the oval-shape plate to the edge on the other side of the
mattress away from the bed rail.
The length of the strap can be adjusted using the clasp.
NOTE: So that the barrier is secure, make sure that the fixed
strap is fastened firmly and tightly.
To collapse the bed rail, after fitting it to the bed, press
5.
the side buttons simultaneously and move the rail up or
down as required.
(See figures 5 and 6)
To fold for storage
1- Remove the bed rail from the bed.
2-To dismantle the rail follow the assembly steps in reverse order.
3-Remove the screws from the stabiliser feet and store them in a
safe place.
4-To clean, wipe with damp cloth.
2
2
3
headboard
25 cm (10")
4
mattress
bed
5
6
7
Net
Mattress width
Oval shape plate
16 cm (6,3")
bed rail
bed rail
oval shaped part
mattress
Publicidad
