Important Safety Instructions - Briggs & Stratton 071007 Manual De Instalación Y Del Operario

Important Safety Instructions

This is the safety alert symbol. It is used to alert
you to potential personal injury hazards. Obey all
safety messages that follow this symbol to avoid
possible injury or death.
The safety alert symbol ( ) is used with a signal word
(DANGER, CAUTION, WARNING), a pictorial and/or a safety
message to alert you to hazards. DANGER indicates a hazard
which, if not avoided, will result in death or serious injury.
WARNING indicates a hazard which, if not avoided, could
result in death or serious injury. CAUTION indicates a hazard
which, if not avoided, might result in minor or moderate
injury. NOTICE indicates a situation that could result in
equipment damage. Follow safety messages to avoid or
reduce the risk of injury or death.
The manufacturer cannot possibly anticipate every possible
circumstance that might involve a hazard. The warnings in
this manual, and the tags and decals affixed to the unit are,
therefore, not all-inclusive. If you use a procedure, work
method or operating technique that the manufacturer does
not specifically recommend, you must satisfy yourself that
it is safe for you and others. You must also make sure that
the procedure, work method or operating technique that you
choose does not render the transfer switch unsafe.
WARNING
Only qualified electricians should attempt installation of
this system, which must strictly comply with applicable
codes, standards and regulations.
WARNING
Low voltage wire cannot be installed in same
conduit as power voltage wiring.
• Failure to follow above warning could cause personal
injury, damage and/or malfunction of equipment.
4
Save These Instructions
• DO NOT touch bare wires or receptacles.
• DO NOT use transfer switch with worn, frayed, bare or
otherwise damaged wiring.
• DO NOT handle electrical cords while standing in water,
while barefoot, or while hands or feet are wet.
• If you must work around a unit while it is operating,
stand on an insulated dry surface to reduce shock
hazard.
• DO NOT allow unqualified persons or children to operate
or service transfer switch.
• In case of an accident caused by electrical shock,
immediately shut down the source of electrical power
and contact local authorities. Avoid direct contact with
the victim..
• Despite the safe design of the transfer switch, operating
this equipment imprudently, neglecting its maintenance
or being careless can cause possible injury or death.
Improper treatment of transfer switch can damage it and
shorten its life.
• Use transfer switch only for intended uses.
• If you have questions about intended use, ask dealer or
contact Briggs and Stratton Power Products.
• DO NOT expose transfer switch to excessive moisture,
dust, dirt, or corrosive vapors.
• Remain alert at all times while working on this
equipment. NEVER work on the equipment when you are
physically or mentally fatigued.
• If connected devices overheat, turn them off and turn off
their circuit breaker/fuse.
WARNING
Failure to properly ground transfer switch can
result in electrocution.
WARNING
Transfer Switch contains hazardous voltage
that can cause personal injury or death.
NOTICE
BRIGGSandSTRATTON.COM