HoMedics MyBaby SoundSpa Lullaby Manual De Instrucciones E Información De Garantía página 4

USING THE PICTURE PROJECTION
Note: The projector lid must be completely closed, pushed all the way down, in
order for the picture projector to function properly.
1. Turn on the projector by pressing the PROJECT button (Fig. 1). The projector
will begin projecting at the lowest brightness setting.
2. Press the PROJECT button again to adjust the brightness to the highest setting.
3. When finished using the picture projection, you may turn it off by pressing
the PROJECT button again.
Note: SOUNDS and PROJECT are independent functions. You can use one at a
time or together.
FIGURE 4
6
CHANGING THE DISC IMAGE
1. Make sure projection is off and lift off the projector lid.
2. Gently rotate the disc until the desired image scene is over the lens. You will feel
a click every time the new image is secured in place.
Note: the image disc will only rotate a maximum of 2 positions (clicks) in a clockwise
or counterclockwise rotation. If the image will not rotate in one direction, try rotating it
in the opposite direction. (FIg. 5)
3. Place the projector lid back on the unit and adjust until you hear the lid snap in place. (Fig. 4)
Note: The projector lid must be completely down and snapped in place in order for
the picture projector to function properly
FIGURE 5
7