FIGURE 6
USING THE AUTO-TIMER
1. When the sounds and/or projection are on you may set a timer so the unit
will automatically turn off.
2. Toggle through the TIMER button (Fig 6) until the time of your choice, 15,
30, 45 or 60 minutes, is illuminated on the timer display. The selected time
will remain illuminated to confirm that the timer is set.
MAINTENANCE
To Store
You may store the unit in its box or a cool, dry place.
To Clean
Wipe off with a damp cloth. NEVER use liquids or abrasive cleaners to clean.
Modifications not authorized by the manufacturer may void users authority to
operate this device.
8
TIMER DISPLAY
FCC DISCLAIMER
Note: This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference caused
by unauthorized modifications to this equipment. Such modifications could void
the users authority to operate the equipment.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harm-
ful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help
IC CAUTION
ICID: RSS-GEN ISSUE 4 DECEMBER 2014
This device complies with industry Canada License-exempt RSS standard(s).
Operation is subject to the following conditions: (1) This device may not cause
interference, and (2) This device must accept any interference, including that
may cause undesired operation of the device.
9