DBI SALA Advanced 8563700 Manual Del Usuario página 4

5. Once the desired height is selected and the tank pod secured on top of the hatchway, turn the
two adjustment knobs (A) on the main body toward the center section. This will stabilize the
unit during use. Note: It is not always possible that you will not be able to achieve the desired
height when position is a factor as well.
6. To secure the winch-mounting bracket, remove the two 7.6cm pins (H) and one 10.2cm pin (E)
from the bracket. Place the bracket over the back leg on the main body and replace the two 7.6cm
pins (H) behind the leg. Once secured, replace the 10.2cm pin through an open hole on the leg
tube. If no open hole is present, remove the positive lock pin partially back and push the 10.2cm
pin (E) through the that same hole. Completely remove the positive lock pin and push the 10.2cm
pin (E) completely through.
7. Secure the winch-mounting bracket on the tank pod bracket by removing the two 9.5mm pins
and placing it over the tank pod bracket and replacing the pin in the available holes.
8. Mount the winch or SRL in accordance to the operator's manual.
9. Remove the top two 9.5mm pins (F) on the main body and place your cable over the rollers.
Replace your pins to assure the cable does jump the path during use.
10. The anchor point (G) located on a front side of the main body is an approved anchorage point
for secondary lifelines such as rope drops and retractables.
4