DBI SALA Advanced 8563700 Manual Del Usuario página 6

STUD LOCATIONS
C L
studs shown for illustration
purposes only
C L
ENTRY
20cm
STEP 1
piping, motors, pumps etc. Also make sure the digital winch has room for mounting
and cranking of handle.
STEP 2
the
bottom of each leg. Make sure the studs are screwed into the foot pad fully by coming
in
contact with the flats of both stud & foot pad.
STEP 3
mounting ring into place. Things to remember before tacking the studs is as follows:
itself. You can do this by measuring the entry diameter and adding how many
inches you may require to mount the tank pod and adjust the outer legs evenly from
the center tank pod leg.
center or greater of the hatchway itself.
possible to the back for minimum interference when entering and exiting hatch entry.
to one side of the entry, the left & right hand side leg heights need to be adjusted
accordingly to keep the main body tube in a level position.
STEP 4
the stud ball and tack into position.
STEP 5
winch onto the tank pod's winch bracket & examine the clearances during handle
rotation.
Installation of the Tank Pod
STEP 1
that the outside legs are evenly spaced from the middle leg on the Tank Pod.
STEP 2
STEP 3
to welded on stud assemblies and screw foot pads onto the stud until flats come in
contact with each other.
STEP 4
Then pin the center leg into position.
STEP 5
STEP 6
45°
11.4cm
Ø4.5cm
10cm
Ø7.1cm
Get a general idea of where to locate the Tank Pod with minimum interference of
Mount the 3 studs to the tank pod by screwing them into the threaded foot pads at
You will now need assistance to locate the tank pod on the tank tack the stud &
a) Keep the legs of the tank pod approximately 10cm-20cm away from the entry
b) The left and right leg studs need to be located across from each other over the
c) Make sure the cable path for the winch enters the hatch entry as close as
d) If there is enough interference where the tank pod needs to be positioned off
Once all these factors have been considered place the stud mounting rings under
Before welding up the stud assemblies with a seal welds all around, mount the
Adjust leg width by screwing the leg nut in or out on main body tube. Make sure
Make sure leg tubes are pinned prior to lifting the Tank Pod into position.
Once lifted into position, remove all 3 pins from leg assemblies for easier mounting
Pin the outside legs first making sure to get maximum height and level as possible.
Mount the winch brackets.
Mount the winch accordingly to your operators manual.
6
1.28cm
3.81cm
2.54cm