Bosch PS60 Instrucciones De Funcionamiento Y Seguridad página 9

2610051984.qxp_PS60 3/17/20 9:48 AM Page 9
measures reduce the risk of starting the tool accidentally.
Inserting and Releasing
Battery Pack
otherwise damaged, do not insert into
tool. Battery can fall out during
operation.
Release battery pack from tool by
pressing on both sides of the battery
release tabs and pull downward (Fig. 2).
To insert battery, align battery and slide
battery pack into tool until it locks into
position. Do not force.
Preparing the Saw
BLADE SELECTION
No one blade can be efficient on all
cutting jobs. Different materials require
specially designed blades. Since your
reciprocating saw can cut so many
materials, many types of BOSCH blades
are available. Be sure to use the proper
blade to ensure proper cutting
performance.
INSTALLING A BLADE
1. Insert the blade into the blade holder
by twisting the collar in direction of
arrow until it stops (Fig. 3).
2. Insert a blade into blade slot until
blades shoulder rests against the
collar.
3. Release collar and spring loaded
collar will securely clamp the blade.
(Note: If the collar does not return to
it's original position, rotate the collar
in direction opposite of the arrow.)
4 Push in and pull out on the blade to
be sure the pin in the clamp housing
goes through the hole in the blade to
hold the blade securely. The blade
may be inserted with the teeth facing
down or up.
Assembly
Disconnect battery pack from tool before making any assembly,
adjustments or changing accessories. Such preventive safety
If battery release
tabs are cracked or
Fig. 3
SAW BLADE
BLADE SLOT
COLLAR
5. To remove the blade, rotate the collar
in direction of arrow while pulling the
blade out of the blade slot. (Note: be
careful, blade may be hot.)
blade extends through the footplate
for the entire stroke length. Do not use
specialty blades that are very short or
those with a significant cant. Blade
must not contact footplate. A blade
which is too short or tilted could jam
inside the foot and snap.
-9-
Fig. 2
BATTERY
RELEASE
TABS
OPEN
POSITION
Make sure that the
front end of the