Celestron 44320 Manual De Instrucciones página 6

Kit del microscopio digital
Ocultar thumbs Ver también para 44320:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

ATTACHING YOUR DIGITAL IMAGER TO YOUR MICROSCOPE
After installing the software and confirming the microscope
imager is working with your software, you are ready to attach
the imager to the microscope. This step can be done before
the software install, if you prefer. Just make sure to follow the
installation steps with the imager disconnected.
First, you need to remove the zoom eyepiece Fig. 1 (1)
from the eyepiece tube Fig. 1 (2) by turning it past the stop at
the 10x position. Put a little pressure on the eyepiece (and
one hand on the base for support) and continue turning
it counterclockwise to unthread it from the eyepiece
tube. Take the protective cap off of the imager. Next, thread
the imager into the eyepiece tube (clockwise) without
overtightening. Lastly, plug the USB cable into an open
USB port on your computer.
F
igure
VP-EYE SOFTWARE
The software package you installed is called VP-EYE. The
software allows you to observe specimen slides or objects on
your computer. When you view with the imager installed, the
magnification depends on the objective lens you are using
and also the size of your PC monitor.
Plug in the USB cable of the microscope imager to your
computer.
VP-EYE contains basic image capture and organization for
your photos (snapshots) and videos. Click on the VP-EYE
icon to begin (or from the programs in the Start menu of your
computer). The software is very intuitive and easy to use.
MAGNIFICATION USING DIGITAL IMAGER — ESTIMATES
4x Objective
15x Objective
30x Objective
7
F
a
igure
using a 14" monitor —150x
using a 14" monitor —650x
using a 14" monitor — 1300x
Please note: Many keyboards on Macs have a USB port.
The microscope will not work through this USB port
because it does not have enough power. You will have to
connect the USB directly to your computer.
When viewing or imaging a specimen slide or object, you can
change the orientation of the image on the computer screen
by rotating the imager to the position you desire – generally
do this counterclockwise so you don't tighten the imager in the
eyepiece tube.
From left to right below - digital imager with USB cable
(Figure 7A), eyepiece tube (Figure 7B), imager connected to
the eyepiece tube (Figure 7C), microscope with the imager
attached, connected to a computer with the USB cable
(Figure 7D).
7
F
7
b
igure
c
Note: The software package may not have some
of the programs listed due to the version of this
software package. You can print out a short
instruction sheet from the installed software. If you
need additional information about the software,
visit http://www.mmedia.com.tw.
5
F
7
igure
d

Publicidad

Tabla de contenido
loading

Tabla de contenido