Tabla de contenido
Publicidad
US
Installation Instructions
NEW or USED TIRE TREAD: Then select between NEW TIRE and
USED TIRE using the knob. Press the right knob to confirm.
If tire data corrections are needed, select MODIFY again to enter the
correct data and then press the right knob to confirm.
Choose the entered data with the right knob and press the knob to
confirm. The unit will restart and be ready to navigate.
Service Menu: CALIBRATION RIDE
Select CALIBRATION RIDE to check the calibration status (e.g. Status:
2) and the type of positioning (e.g. 3D).
After calibration, WHEEL and REVERSE on the display will be replaced
with the street name where you are currently driving, provided the area is
digitized.
Status 1: Navigation not available.
Status 2: Navigation available, but navigation announcements may not
be as timely as Status 3.
Status 3: Navigation available at optimum accuracy.
Service Menu: MODULE TEST
Select MODULE TEST to activate a test of the internal components of
the navigation system. If OK is displayed, press the NAV button to
return to Service Mode.
Service Menu: SENSORS
Select SENSORS to activate a test of the speed signal, reverse signal
and internal sensors.
• For the speed signal test, drive the vehicle several yards forward and
backward. The number following WHEEL: will change while the vehi-
cle is moving.
• In reverse gear, the number following REVERSE: will change from 0 to
1 or from 1 to 0.
• For the internal sensor test, drive around a curve. The values following
X: and Y: must change.
To exit the sensor test and return to Service Mode, press the NAV button.
Subject to correction and technical modifications
2L2Z-18814-NAV
55/71
SK2L2J-10E945-AA
©
Copyright Ford 2002
Publicidad
Tabla de contenido
