Bosch GWS18V-13C Instrucciones De Funcionamiento Y Seguridad página 12

measures reduce the risk of starting the tool accidentally.
Inserting the Bluetooth
Connectivity Tool Module
Read the corresponding
instructions for information about the
Bluetooth® Connectivity Tool Module.
Vibration Control Side
Handle
The side handle is used to control and
balance the tool. The handle must be thread -
ed into the front housing on either side of the
tool, depending on per sonal preference and
comfort. Use the side handle for safe control
and ease of operation (Fig. 1).
Hand Shield
(sold separately)
The hand guard is to be used with backing
pads, sanding discs and wire brushes to keep
fingers and hand away from work surface,
sharp edges, burrs and debris. When using
the optional hand guard accessory insert side
handle through hole in guard and then thread
into housing (Fig. 1).
Ensure that hand guard is positioned
between hand and backing pad, sanding disc
or wire brush.
Wheel Guard Installation
grinding or cutting wheels. Always keep
wheel guard be tween you and your work
while grinding or cutting.
TO ATTACH WHEEL GUARD
Disconnect battery pack from tool.
Press and hold the release lever (Fig. 2),
and place the guard on the guard mounting
flange until the guard's keys line up with the
notches in the spindle collar (Fig. 2A).
Press the guard onto the guard mounting
flange until the shoulder of the guard is
Disconnect battery pack from tool before making any assembly,
adjustments or changing accessories. Such preventive safety
operating
Wheel guard must be
attached when using disc
Assembly
GUARD
RELEASE
LEVER
A
seated against the flange of the tool, and
turn the guard until it can clearly be heard
to engage.
Adjust the position of the guard to the
requirements of the work process. For this,
press the release lever upward and turn the
guard until it clicks into place then adjust as
needed.
• Always adjust the guard in such a manner
that all 3 red cams of release lever engage
into the corresponding notches of the
guard (Fig. 2B).
• Adjust the guard in such a manner that
sparking is prevented in the direction of
the operator.
• The guard should turn only upon
actuation of the release lever! Otherwise
the tool may not continue to be used
under any circumstances and must be
taken to an after-sales service agent.
-12-
FIG. 2
GUARD
MOUNTING
FLANGE
KEYS
B