Bosch GWS18V-13C Instrucciones De Funcionamiento Y Seguridad página 15

Abrasive TYPE 41/1A and
27A Wheel Assembly
Using the optional Type 41/1A wheel guard,
it is possible to perform limited cutting on
small stock such as metal tubes, piping or
rebar.
Do not attempt to cut large stock or sheets
of metal as this tool is not designed to be a
dedicated cutting tool.
cutting.
Disconnect battery pack from tool. Be sure
that wheel guard is in place for cutting.
When using mounting wheels, thread
BACKING FLANGE onto spindle, then place
WHEEL on the spindle. Thread on the lock
nut and tighten nut using a lock nut wrench
provided with adapter kit, while holding the
spindle lock in (Fig. 5).
TO REMOVE: Reverse procedure.
Type 41/1A Abrasive
Straight Grinding Wheels
for straight/die grinding. This tool is not
designed for use with Type 41/1A abrasive
straight/die grinding wheels.
Always use Type 41/1A
protection guard for
Do not use Type 41/1A
abrasive wheels designed
Assembly
TYPE 41/1A
CUTTING WHEEL
TYPE 27A
CUTOFF
WHEEL
-15-
SPINDLE
TYPE 41/1A
WHEEL GUARD
(OPTIONAL)
BACKING
FLANGE
QUICK-
CLAMPING NUT
LOCK NUT
(sold separately)
FIG. 5
TYPE 27A
CUTOFF
WHEEL
SPINDLE
BACKING
FLANGE