Bosch GWS18V-13C Instrucciones De Funcionamiento Y Seguridad página 16

Sanding Accessories
Assembly
BACKING PAD
maximum safe operating speed is not
exceeded by the nameplate speed of the
tool.
operations. Always reinstall wheel guard
when converting back to grinding operations.
backing pad for sanding accessories.
TO INSTALL BACKING PAD AND
SANDING DISC (Not Included)
Disconnect battery pack from tool.
Attach hand shield. Set the tool on its top
side (spindle up). Place the rubber backing
pad onto the spindle shaft. Center the
sanding disc on top of the backing pad.
Insert the lock nut through the disc and
thread onto the spindle as far as you can
with your fingers. Press in the spindle lock,
then tighten the backing pad securely with
lock nut wrench (Fig. 6).
TO REMOVE: Reverse procedure.
WIRE CUP BRUSH ASSEMBLY
Disconnect tool from the power supply.
Attach hand shield (Fig. 1). Wire cup
brushes are equipped with their own
threaded hub, simply thread on to spindle.
Be sure to seat against shoulder before
turning tool "ON".
TO REMOVE: Reverse procedure.
WIRE WHEEL ASSEMBLY
Disconnect tool from the power supply.
Install type 27 guard (Fig. 7). Wire wheels
are equipped with their own threaded hub,
simply thread on to spindle. Be sure to seat
against shoulder before turning tool "ON".
TO REMOVE: Reverse procedure.
Before attaching
backing pad be sure its
Wheel guard may not be
used for most sanding
Do not use the Quick-
Clamping Nut
Assembly
FIG. 6
a
SPINDLE
with
FIG. 7
SPINDLE
-16-
HAND SHIELD
(sold separately)
(sold separately)
LOCK NUT
(sold separately)
WIRE CUP BRUSH
WHEEL GUARD
WIRE WHEEL
BACKING
PAD
SANDING
DISC
TYPE 27