Change Settings - Scubapro Xtender Manual Del Usuario

Surface time
Beginning 10 minutes after the end of the dive, Xtender shows the surface time,
which is counted for 48 hours and can be displayed by pressing "select". After
48 hours, it will simply show "- -:- -" (Fig. 10).
mode
indicator
Figure 10

CHANGE SETTINGS

Select unit of measure
The pre-selected units of measure are those of the decimal metric system (meters
and degrees Celsius); you can however select Imperial units (feet and degrees
Fahrenheit) for depth and temperature. To choose the desired units of measure,
hold down the "lock" button for approximately 15 seconds.
Dive Planner
Xtender has a dive planner that shows the no-decompression limits between 9
and 48 meters. The planner is activated by pressing the "mode" button and is
indicated by the "plan" button in the lower portion of the display; the "select"
20