Communication Port; Connect The Loads - Atlantis OnePower Sx80 Manual De Instrucciones

1.5 Communication Port

Connect the supplied interface cable to the USB computer interface port on the
back of the UPS. Connect to the computer. See software document for installation
instruction.

1.6 Connect the loads

First, connect the UPS with the AC Mains, then plug the loads into the output
connectors on the rear of the UPS. To use the UPS as a master "On/Off" switch,
make sure that all of the loads are switch "On".
Do not connect a laser printer to the outlets. These UPS
outlets provide battery power and surge protection to the
equipment when utility voltage is outside acceptable limits.
27
ENG