LaserLine Cubus Manual Del Usuario página 14

Special product features and functions
The rotary laser aligns itself automatically. It is set to the required
initial position (to within an operating angle of ± 4°) and the automatic
system then performs the necessary fine adjustment, with three electronic
measurement sensors detecting the X, Y and Z axes.
The anti-drift system (ADS) prevents erroneous or inaccurate
measurements. How it works: continuous monitoring of the alignment of the
laser is activated 30 seconds after the ADS is switched on. If the device moves
due to the influence of external factors or the laser loses its height reference,
the laser will come to a standstill. Additionally, the laser flashes and the tilt
LED is lit continuously. To continue working, press the tilt button again or switch
the device off then on again. Erroneous and inaccurate measurements are
thus prevented simply and reliably.
The ADS is not active following switch-on. Once the device has been set
up, press the tilt button to activate the ADS, enabling you to protect the laser
from changes in position caused by the device being disturbed by external
factors. The tilt LED flashes to indicate that the ADS function is active; see
the diagram below.
The ADS does not activate the monitoring function until 30 seconds
!
after the laser levelling procedure has been completed (set-up phase).
The tilt LED flashes every second during the set-up phase, rapid
flashing, when ADS is active.
ADS function
ON
Adjustment phase
Sensor Automatic
14
GB
ADS active after
30 seconds, rapid
Rotation flashing of the
begins tilt LED.
ADS activation:
press the tilt
button; the tilt
LED flashes every
second.
External
influence
The
laser
remains stationary as
a precaution, the laser
flashes and the tilt
LED is lit continuously.