Care And Maintenance - Bosch SHX36L Manual Del Usuario

DJSHWASHER...continued CARE AND MAINTENANCE USING YOUR
"41 CanceJing or Changing a Cycle
a) To cancel or change a cycle, press
and hold for three seconds the two
buttons labeled "Cancel Drain" as shown
in Figure 15.
Figure 15
b) Wait approximately one minute, then
press the On/Off button
c) You may now begin a new cycle or
select a different cycle.
Dishware Drying
NOTE: Check the Dishwasher Options
section of this manual for information on
the Additional Drying Heat option.
At the end of the cycle the dishwasher
will stop and a period of condensation
drying will follow. After 12 - 15 minutes of
drying,
the "Clean" indicator will illuminate,
the "Sanitized" indicator may
illuminate depending on the cycle
selected and the conditions.
The Cycle Completion Signal will
sound depending on the setting.
NOTE: To accelerate and enhance
Irying, open the dishwasher door, pull
the top rack a few inches out of the
dishwasher, and prop the dishwasher
door against the top rack.
The "Sanitized" indicator
When the "Sanitized" light illuminates,
means that the dishware and
kitchenware that was just washed has
been sanitized according to the
requirements of the National Sanitation
Foundation (NSF). For more information
on NSF certification, go to the Wash
Cycle Information section of this manual.
- The CycJe Completion Signal
This Cycle CompJetion Signal is a tone
that sounds when your Bosch dishwasher
finishes washing and drying your dishes.
You can either disabIe the tone, or you
can set it at one of two volumes (your
dishwasher leaves our factory with the
tone set on the Iower voiume).
To change the Cycle Completion Signal
Volume:
a) Open the dishwasher door far
enough to expose the controt buttons.
b) Press and hold the right "Cancel
Drain" as shown in Figure 16, then press
and hold the On/Off button.
Figu re 16
When the light on the "Cancel Drain"
button you are pressing illuminates and
the tone begins to sound, release both
buttons.
c) Press the right-most "Cancel Drain"
button until the tone is either at the
desired volume or is silent.
d) Press the On/Off Button.
e) Shut the dishwasher door. The
Cycle Completion Signal is now set, and
you may wash your dishes as usual.
Unloading the Dishwasher
1. GeneraJ GuideJines
a) Unload the bottom rack first.
b) UnIoad the silverware basket(s).
They are easiIy removed for unloading.
c) Unioad the top rack.
d) If the Extra Tall Item Sprinkler was
JnstaJIed, return the dishwasher to its
normal condition (see the Loading Extra
Tall Items instructions in the "Loading the
Dishwasher" section of this manual).
CARE AND
Maintenance Tasks
Certain areas of your Bosch dishwasher
require occasional maintenance. The
maintenance tasks are easy to do and
will ensure continued superior
performance from your Bosch
dishwasher. These tasks are:
,, Wiping up Spills and SpJash-out
,, Winterizing Your Bosch Dishwasher
,, Clean the Stainless Steel Inner Door
and Tub
,, Check/Clean the Spray Arm Nozzles
,, Check/Clean the Filter System
,, Clean the Exterior Door Panel
,, Clean the Door Gasket
1. Wiping Up Spills and SpJash-out
Water may occasionally spiash out of
your Bosch dishwasher, especially if you
interrupt a cycle or open the dishwasher
door during a cycle. To avoid floor
damage and possible moJd growth, do
not aIIow wet areas to remain around or
under the dishwasher.
2. Winterizing Your Bosch
Dishwasher
POSSIBLE DISHWASHER
DAMAGE: Freezing temperatures
can damage your dishwasher. Do not
allow water to remain in your dish-
washer water supply or drain sys-
tems through extended periods of
freezing temperatures.
if your dishwasher will be unused for
an extended period of time in a location
that experiences freezing temperatures
(e.g., in a holiday home or through a
vacation period), you must drain all the
water from the dishwasher's interior.
a) Turn off the water supply.
b) Disconnect the drain hose, and
allow your dishwasher to completely
drain into a bucket or other appropriate
receptacle.
3. Check/CJean the Stainless Steet
Inner Door and Tub
a) Clean the outer edges of the inside
door panel regularly to remove debris
that might collect there from normal
loading.
b) If spots begin to appear on the
stainless steel tub or inner door, make
sure the rinse agent reservoir is full.
J
8