VOX Amplification StompLab I B Manual De Usuario página 10

[Lo/Hi] and [Mid] are part of the [AMP/DR] parameter.
If [AMP/DR] is turned off, the effect will be disabled.
Also, you can set the volume level of the program with
the [AMP/DR] VALUE 2 knob (LEVEL).
For noise reduction, select [NR] with the CATEGORY
selector and adjust the sensitivity with the VALUE 1
knob. Adjust the noise reduction sensitivity so that you
don't hear noise (hiss) when you're not playing your
bass. Depending on the bass that you're using, sustaining
notes may be cut off if you raise the noise reduction value
excessively. This parameter should be adjusted so notes
ring out naturally.
Effect/parameter type and parameter value display
In the Edit mode you can switch the effect names or the VALUE 1

and VALUE 2 values indicated with the Program UP/DOWN pedals.
The tuner LED will light up when the effect name is indicated, the
tuner center LED will light up when VALUE 1 is indicated and the
#
tuner LED will light up when VALUE 2 is indicated.
Checking the values saved in a program (Original
Value)
The Original Value LED in the program/value display lets you
check the parameter values of a saved program.
When you use the knob or buttons to modify the value of a
parameter, the Original Value LED will light up when that value
matches the value that's already been saved in the program (i.e.,
the original value).
10
In Program select mode, the Original Value LED will light up
if the values of all parameters match the values that are saved
in the program.
Saving a program — [WRITE]
Here's how to save (write) a sound that you've created.
If you switch to a different program in Program mode or turn
off the power without writing your settings into memory, the
changes that you made will be lost.
1. Set the CATEGORY selector to [WRITE].
The program number will blink in the program/value display.
2. Use the VALUE 1 knob or the / buttons to select the program
location where you want to save your settings.
3. Press the  button and  button simultaneously for 1 second.
The program will be saved, and the program/value display
will indicate " CP " briefly.
The newly saved program will overwrite (i.e., replace) the
existing settings, so the previous program in that location
will be lost.
To cancel saving the program, select a category other than
[WRITE] with the CATEGORY selector.