Module Installation; Module Description - golmar T4502ML Manual De Instalación

MODULE INSTALLATION

E
mbedding box positioning.
1650
The upper part of the module should be placed at 1,65m. height roughly.
The hole dimensions are: 125(W) x 140(Al) x 57(D) mm.
The module has been designed to be placed under most of the environmental conditions.
However it's recommended to take additional cautions like rainproof covers.
Break the bottom flange
to pass the cables through.
26
1850
1450
P
reparing the embedding box.
Pass the wiring through the hole made in
the bottom part of the embedding box.
Level and flush the embedding box.
Once the embedding box is placed,
remove the protective labels
from the attaching door panel holes.
27
H
old the module on the embedding box.
Select a direction to open the module; this selection should ease
the door panel wiring.
The opening direction will be settled through the hinges position,
that must be passed through the header clips as shown.
For example, if the hinges are placed on both clips of the lower
header, the module will open downwards; if they are placed
on the right clips of both headers, the module will open to left.
To hold the module on the embedding box,
insert the hinges in the embedding box lockers
as shown.
Fix the module by using the supplied screws.
Finish the module assembly by pressing the closing heads.
The jumper placed on the right side of the 7 segments display
allows to select between two operation modes:
IP (stand alone mode or to be used with "Stadio Plus" panels)
or C4P . C4P mode is to be used with C4Plus access control
systems only.
MODULE INSTALLATION

MODULE DESCRIPTION

M
odule description
Installation terminal connector is located under the
module protection cover. The correspondance
of each terminal is as follows:
+, – : power supply input.
S : data (only C4Plus mode).
1 : relay common terminal.
2 : relay output.
IP C4P