golmar T4502ML Manual De Instalación página 16

MODULE PROGRAMMING
IP mode allows to use this module in combination with "Stadio Plus"
panels, or to operate as stand alone module. The operation
mode selection is shown on page 27.
To enter into programming mode, a PIN code will be required.
This code of three digits length (override digit zero from left)
is sticked on the relay, placed on the left side of the display.
While programming, the led on the front part of the module
will light red. To exit from the programming mode, wait 20 sec.
from the last operation.
Press C button during 2 seconds.
C
Press arrow "UP" button till the first PIN digit will appears
Press arrow "DOWN" button to move to the next digit.
Press arrow "UP" button till the second PIN digit will
Press arrow "DOWN" button to move to the next digit.
Press arrow "UP" button till the last PIN digit will appears
To validate the code, press C button during 2 seconds:
C
I
P operation mode.
The left digit display will show number 0.
on the display.
The left display will turn off and the center display
will show number 0.
appears on the display.
The center display will turn off and the right display
will show number 0.
on the display.
the display will show the complete code.
In case of valid code, the display will show the
selected operation mode (IP). In case of wrong code,
the display will show the message "E–5" during
10 seconds and will automatically exit from the
programming mode.
28 29
V
alidation of PROXCARD ISO cards
or NEOKEY key holders.
IMPORTANT: this module is to be used with ISO cards or key holders
C
The module will exit from the programming mode afte 20 seconds of no operation.
The display and the led on the front part of the module will be turned off.
MODULE PROGRAMMING
supplied by Golmar. Other proximity items will be not accepted
even if they have the same appearance.
Once a valid PIN code has been introduced, the
display will show the 1st memory position.
Use "UP" and "DOWN" arrows to select the
desired position, from 1 to 500.
Several cards or key holders can be recorded in one
memory position. Remember that the maximum
number of cards or key holders (users) is 500.
When the display shows the desired memory position,
approach the card or key holder to be recorded.
The display will shows the number of cards
recorded in this position (including the one you are
recording). This number will be shown with a dot
on its right bottom part. The display will show the
selected memory position again.
If you are trying to record an already existing card,
the display will show the memory position where
recorded, coming back to the position you are
trying to record it.
Repeat the above steps to record the rest of cards.
To erase existing cards from a specified memory position,
use "UP" and "DOWN" arrows till the display shows
the desired position. Press C button during 3 seconds:
the display will show the number of cards recorded
in this position and will confirm the progress by
showing the message – – –.
To erase all the existing cards, press C button during
15 seconds aproximately: the display will show the
message "IP" once the memory is empty.