Remote Control Start-Up - THOMSON LENS 200 Manual Del Usuario

MOTORISED 1080P INDOOR SECURITY CAMERA PACK
C - INSTALLATION
Release it and wait until the LED light turns off;
the position is now saved and any movement or
direction change will be detected.

5 - REMOTE CONTROL START-UP

To pair your remote control with your security pack
you must first connect the battery; remove the
battery protection by gently pulling it.
Then press on the camera "Reset" button
for two seconds. The camera will display a message
in English indicating that it is ready to receive the
remote control signal.
Press any button on your remote. The camera should
respond by displaying a new message.
10
EN
RESET
Press the camera's "Reset" button again for two
seconds. The camera will exit learning mode and
the remote control is now configured.
RESET