Cancellation Of Radio Control Codes; Installation Of The Anemometer Windy; Programming The Anemometer's Tripping Speed - ACM Tronic Instrucciones Y Advertencias Para El Instalador

7. CANCELLATION OF RADIO CONTROL CODES

It may become necessary to cancel all the radio command codes memorised, including the "MOTHER"
in case of loss. To do so, press and hold down the external push button (in stop position) until the gear
motor signals that the codes have been cancelled through three short consecutive UP and DOWN cycles
of the blind.
When the external push button is missing, the following procedure can be carried out by simulating
the putting on of the push button, through the connection of the red and black cable (low tension com-
mands, see paragraph 12).
Remember that in the subsequent memorising of new codes, the first radio command will be coded
and recognised by the central unit as the new "MOTHER".
Proceed as follows to memorise the "MOTHER" radio control switch.
1. Connect the control unit to the power supply;
2. Press and hold down both buttons of the radio control until two brief movements of the blind/aw-
ning (one up and one down) are observed. This indicates that Eagle is in programming mode.
3. Press a key on the "MOTHER" radio control switch to be memorised. At this point the Eagle
memorises the "MOTHER" radio control switch and automatically exits from programming
mode.

8. INSTALLATION OF THE ANEMOMETER WINDY

If the wind is too strong it may damage the bearing structure of the blind or the blind itself. To
prevent that, the " TRONIC
The anemometer is installed near the blind, well exposed to the wind, and connected to the red and
white wires. For the electrical connections see fig. 6 paragraph 12.
The anemometer intervention threshold can be set for 2 speeds; 15 kph.
N.B. INTERVENTION BY THE ANEMOMETER INHIBITS OPERATION OF THE RADIO CONTROL
UNIT AND OF THE EXTERNAL PUSH BUTTON FOR ABOUT 8 MINUTES.
Warning! Verify that the intervention of the anemometer actually completes the closure run of the
awnings, if this were not the case, invert the direction (see paragraph 2).

9. PROGRAMMING THE ANEMOMETER'S TRIPPING SPEED

Using the Tronic, you can set the tripping speed of the anemometer (15 km/h or 30 km/h) simply by
using the "MOTHER" radio control.
Programming should be performed as follows:
1)Power the "Tronic";
2)Press and hold down both the keys on the "MOTHER" radio control until the gear motor (through
two brief awming movements, one upwards and the other downwards), displays entry into pro-
gramming mode;
3) Press any key on the "MOTHER" radio control;
The gear motor will display the anemometer's current tripping speed setting as follows:
• a brief gear motor movements in each direction (opening/closing)
• 2 brief gear motor movements in each direction (opening/closing/opening/closing)
4) At this point, if you wish to alter the tripping speed, press any button on the "MOTHER" radio control:
Each time the key is pressed, the gear motor will show the tripping speed setting (as described in
point 3).
5) Once the desired speed is set, in order to exit programming mode, simply wait approximately 30
seconds without performing any operations.
N.B.! if the "mother" radio control is lost, in order to programme the tripping speed you will need to
cancel the stored codes and re-programme the "mother" radio control (follow the instructions in
paragraph 7).
" control unit has been prepared for installation of an anemometer.
15 km/h
30 km/h
15