Warnings For Installation; Technical Characteristics; Electrical Connection Diagram; Indicators Under Development - ACM Tronic Instrucciones Y Advertencias Para El Instalador

10. WARNINGS FOR INSTALLATION

• The Tronic must be installed only by qualified personnel.
• The installer must provide for protection of the device by means of a differential magneto-
thermic breaker (with at least 3 mm distance between the contacts) that ensures detachment of all
poles from the mains in the event of a fault.
• In the event of a fault, the wiring supplied with the device must be replaced by the manufacturer or
by qualified personnel.

11. TECHNICAL CHARACTERISTICS

Power supply: 230 V AC
Relay contact rating: 10 A
Receiver sensitivity – 105 dBm for S/N = 17 dB with carrier modulation 100 %.
Power supply to external push button: 24 V DC
Motor working time: 120 s. The Tronic interrupts movement of the gearmotor after about 120 s of continuous
operation. This is to prevent the motor heating if, for example, the limit switch fails to function properly
TRONIC conforms to Directive 99/05 and that the standards shown in the table have been applied.
Electrical safety
EN 60335-1

12. ELECTRICAL CONNECTION DIAGRAM

BROWN
GREY
BLACK
JELLOW/GREEN

13. INDICATORS UNDER DEVELOPMENT

TRONIC INDICATES THE PROGRAMMING STATUS THROUGH THE MOVEMENT OF THE BLIND
16
Electromagnetic
ANTENNA
FIG.6
compatibility
ETS 300 683
EXTERNAL PUSH BUTTON
CONTROL 24Vdc
BLACK
WIRE B.T. 24Vdc
RED
WHITE
NEUTRE
GREY
PHASE
BROWN
JELLOW/GREEN
TRONIC IS WAITING TO RECORD A NEW
RADIO COMMAND OR TO REVERSE THE
DIRECTION
TRONIC INDICATES THAT THE DIRECTION
HAS BEEN REVERSED (INSTALLED TO THE
LEFT)
TRONIC INDICATES THAT ALL RADIO
COMMAND CODES HAVE
CANCELLED
Efficacious use
of the spectrum
EN 300 220-3
ANEMOMETER
ANEMOMETER
"PB"
"WINDY"
OMNIPOLAR DEVICE
BEEN