Installing Battery; Charging Battery - Soundcast VG5 Manual Del Usuario

ENGLISH | How to use VG5
Congratulations and thank you for your purchase of the Soundcast VG5.
Please read the operation instructions carefully before use.
Quick Start Guide
Box Includes:
3.5mm AC Wall Battery
analog Charger Pack
audio with
cable Adaptor
clips

Installing Battery

1. Using a Phillips #3 screwdriver, unscrew and
remove battery cover located on bottom of VG5
2. Connect the battery to the VG5 connector which
will only fit in the proper direction
3. Route the battery wires
4. Re-install battery cover
4

Charging Battery

Before initial use, charge battery for at least 5 hours to
full capacity. To ensure battery longevity and maximum
performance of the system, the battery should always
be charged prior to mobile operation.
1. Plug-In the included AC Wall Charger to AC power
and connect the other end to the VG5 DC In port
located behind the port protection cover of the VG5.
2. The VG5 can be operated from AC Wall Current
even when battery is fully discharged
3. Charge time is approximately 4-5 hours from fully
discharged battery
4. Playtime varies from depending upon volume level
Orange Power/
Charging
Indicator LED
Status
Power ON
Power OFF
Battery Low
Charging
Fully Charged
Fully Charged Solid Orange (if power on)
Error- Cannot Charge
Ports, Connections and Inputs
Weather Resistant
Charging & Access
Ports Location
Battery access panel
Charging & Access Ports
Power LED
Solid Orange
Off
Slow Blinking Red
Solid Red
Off (if power off)
Fast Blinking Red
Capacitive Touch Control Keypad
NFC (Near Field
Communication)
Location
Comfort-Grip
Carry Handle
DC IN
USB/
15V 1.5 A
AUX IN
SERVICE RESET
USB Power Bank
Charging Output